Honeywell K14392V1 manual PPP IP Settings Reserved for Modem Connection, To Set an External Modem

System Administrator’s Guide

Table 8–3 Default Modem and Dial-up Communications Settings

Device	Box	Value
Modem hardware	Baud	115,200
	Wait	60
	Prefix	AT
	Initialization	Z
	Dialing	D
PPP temporary network	Client IP	172.26.200.1
	Host IP	172.26.2.1

PPP: IP Settings Reserved for Modem Connection

During a dial-up connection, temporary network communications are established between the Rapid Eye site and the PC. A Host IP address for the Multi-Media unit is auto-detected by the Microsoft Dial-Up Networking application in Windows. Different terms are used to describe these communication points; to avoid confusion, these terms are listed in table 8–4.

Table 8–4 Names of Temporary TCP/IP Addresses, for PPP

Address*	Internal Port	Laymen’s term	Installation shell
172.26.200.1	PPP: client IP	at operator’s PC	host
172.26.2.1	PPP: host IP*	at Multi-Media unit	local

*This is not the Multi-Media unit’s network address, discussed in System Tab in a Maintenance Session.

The default, point-to-point protocol (PPP) Internet Protocol (IP) settings can be changed, in the unlikely event that they conflict with another network device (printer, scanner, and so on).

To Set an External Modem

1.Consult the installer to find out which port on the unit is connected to the modem.

2.Continue or start a Maintenance Session for the Rapid Eye site.

3.Click the Serial Devices tab.

4.Click the “Internal Port - Modem” icon. Boxes appear in the right half of the Serial Devices tab: Baud Rate, Wait for connection and so on.

5.Change the values to those suggested by the external modem’s documentation.

6.Drag the modem icon to the port icon bearing the number of the port identified in step 1.

Document K14392V1 Rev A	139
07/07