Honeywell K14392V1 manual Adjusting a Unit’s IP Settings for NAT

System Administrator’s Guide

Adjusting a Unit’s IP Settings for NAT

Fig. 3–9. NAT Configuration: Changing the IP Address of a Multi-Media Unit.

1.Ask the network administrator of the remote LAN for the unit’s:

•IP Address

•Subnet Mask

•Gateway. The Gateway on the unit matches the router's Inside IP address; for example, in figure 3–9,it is set to 192.168.101.1.

2.Enter the values obtained in step 1 using either:

•LocalView software, onsite. Click the Setup tab and then click the System tab. Use the buttons in the Network Settings box.

- or -

•A PC that runs View and that can connect to the Multi-Media units. Run a Maintenance Session to the unit. The values are entered on the System tab. See figure 3–9.This locks out View operators from further use of the unit until the router and Multi db are updated. See Setting a Router’s Mappings and Updating a Unit's Connection. Operators using LocalView are not locked out.

Document K14392V1 Rev A	39
07/07