Honeywell K14392V1 manual Support for RapidDome PTZ Features, RapidDome PTZ Tours

System Administrator’s Guide

Support for RapidDome PTZ Features

A Multi SA can preset a RapidDome PTZ dome, using View software, for:

•Mimic tours. A mimic tour recalls the commands to pan, tilt and zoom, that were sent to a RapidDome camera. Mimic tours are also known as path tours.

•Preset tours. A “preset tour” recalls a list of PTZ presets. Before setting up a preset tour, someone is needed to setup presets.

•Privacy zones. Use presets 100 to 127. The video feed is not displayed when a dome is positioned at these presets.

Fig. 6–10. Detail of PTZ Setup for the RapidDome Driver.

Detail of PTZ setup for the RapidDome Driver, on the Video tab, during a Maintenance Session. Details show controls for the mimic tour (1), preset tour (2) and privacy zone (4). The selection of presets and tours is made using the list (3) above the PTZ controller. In the list, “Vector” is used to select a preset tour.

RapidDome PTZ Tours

1.In the PTZ controller, click the arrow in the box under the row of numbered button to display a list, showing: “Preset, “Tour” and “Vector”. See figure 6–10–(3), on page 95.

2.Do one of the following:

•For mimic tours, select “Tour”.

•For preset tours, select “Vector”.

3.Click a button in the row of numbered buttons, above the box that shows the list.

Document K14392V1 Rev A	95
07/07