System Administrator’s Guide

Network Connection to an Alarm Station

Tip

Your Rapid Eye site might not need this type of connection to an alarm station.

For other means of connecting to an alarm station, see table 11–2on p. 204.

Fig. 11–2. Over a Network, Alarm's Are Sent to an Alarm Station’s IP Address.

To Setup a Network Connection to an Alarm Station

1.While adding or updating an alarm station definition in the Add Alarm Station/Update Alarm Station dialog box, select Use Existing Network Connection.

2.In the IP Address box, type the alarm station’s address. An IP Address is mandatory for a network connection.

3.Click Save and Close. The Alarm Stations tab appears. In the tab’s Connection Method column, the first letter of “network” appears in parentheses: “(n)”, followed by the

IP address used to connect to the alarm station.

4.The next step is Making an Alarm Station Operational; see p. 218.

Document K14392V1 Rev A

205

07/07

 

Page 205
Image 205
Honeywell K14392V1 manual To Setup a Network Connection to an Alarm Station