Honeywell K14392V1 manual Using a PTZ Camera, To Display the PTZ Dartboard Control

Pan, Tilt, and Zoom (PTZ) Setup

Table 6–1 PTZ drivers for controllers and domes

Driver (name)*	Baud (rate)	Support for (dome/controller/PIT device)
Bossware	19200	PIT device, to which domes are connected.
Honeywell Fixed Camera	9600	Honeywell HCU484
Intellibus	38400	ACUIX dome camera
Javelin 308	9600	Javelin 308 Controller
Kalatel	9600 or 2400	Kalatel KTD 312 Cyberdome
Pelco D	4800, 9600, or 2400	Pelco D
Pelco P	2400	Pelco P
Rapid Dome/Orbiter	9600	RapidDome or Orbiter
SensorMatic RS422	4800	SensorMatic RS422: Delta and Speed
Ultrak (using VCL)	2400	Ultrak (configured as VCL)
Ultrak KD6	9600	KD6, HD6, HD6i

*The drivers are not listed alphabetically in the software. A driver can be used with domes other than those listed. For other domes, controllers or PIT devices, consult their documentation.

Using a PTZ Camera

Three PTZ controls are available to make PTZ commands: a dartboard-like control, a rubber band control and a Zonal Mode control.

Either is available while running a Live session or while using LocalView. The right to use a PTZ camera is granted in the operator’s Multi-Media account; see Granting Rights, p. 158.

To Display the PTZ Dartboard Control

The PTZ dartboard control can be obtained in three situations:

•During a Maintenance Session, when PTZ is selected, the PTZ control is displayed on the video tab. See the first steps of procedure To Enable a PTZ Camera, above.

•During a Live session, select or add a video stream from a PTZ camera. Click , the "Enable PTZ Control" button.

•In LocalView, a “PTZ” button is shown when a Live tab is selected. It is available when a PTZ camera is selected.

88