Honeywell K14392V1 manual Unit Configuration Basics, Maintenance Session, Using View

Models: K14392V1

1 260
Download 260 pages 3.89 Kb
Page 53
Image 53

4

Unit Configuration: Basics

Maintenance Session

Using View

View software is used to run a Maintenance Session on a Rapid Eye Multi-Media unit, not Admin software. The Maintenance Session is discussed in this System Administrator’s Guide because the session is designed to be used by the system administrator (the Multi SA) designated by your organization, to maintain and supervise your Rapid Eye System.

Using a Maintenance Session

The Maintenance Session is used to configure:

System hardware. Cameras, Multi Audio, motion detection, scheduling, and other hardware connected to the unit.

Security. Events Defined that trigger alarms and other security settings. See also Updating Security on a Multi-Media Unit, on p. 131.

Scope of a Maintenance Session

A Maintenance Session involves only the unit on which it runs. You can use View software to open a Maintenance Session on more than one unit at a time. Two operators cannot each run a Maintenance Session on the same unit. While a Maintenance Session runs, the unit’s LocalView interface continues to display video but is unavailable for unit operation.

A Maintenance Session is also used to:

Make a site operational. Running a Maintenance Session is needed before operators can start using a Multi-Media site; see Making a Site Operational, p. 55.

Obtain a unit’s statistics. See Hardware Report, p. 140 and To Obtain a Unit’s Statistics, p. 128.

Document K14392V1 Rev A

53

07/07

 

Page 53
Image 53
Honeywell K14392V1 Unit Configuration Basics, Using View, Using a Maintenance Session, Scope of a Maintenance Session