Honeywell K14392V1 manual Event Reference, Outside World

Security for a Multi-Media System

Event Reference

Table 10–5 Event Reference, by Source and Tab

Source	Event in Maintenance, Except	Cause: an Alarm or Log Entry Could
	Where Noted	Indicate …
Outside World	System: no video recording*	a cut cable, dead camera, power outage
event

Inputs: activate, input ports 1 to 16

Inputs: deactivate, input ports 1 to 16

Video: signal unlock, cameras 1 to 16

	Video: lock†, cameras 1 to 16
	Motion: On the Video tab
	(not on the Event tab).
	Camera Sabotage Detection:
	On the Video tab
	(not on the Event tab).
Customer-	user defined: Not on Event tab;
device event	on Serial Devices tab.
View Operator	Session: connect, reject and
event	disconnect
	Maintenance: changes to
	configuration, security, time,
	storage and so on…‡
	Outputs: activate, output ports 1
	to 8
	Outputs: deactivate, output
	ports 1 to 8
	System: no video recording*
	System: reboot
Multi-Media Unit	System: failure, self-restart,
event	reboot†
	System: No video recording*
	System: time server, no synch,
	clock drift…
	System: disk failure

security sensor has been triggered or the Multi-Media unit is booting

security sensor has been reset or the unit is booting

cut cable, hardware failure in a Rapid Eye Multi Multi-Media unit, faulty camera… Can be momentary.

a buggy camera; time since video unlock helps troubleshooting

intruder, a change in lighting, fire, an explosion, vermin, and so on.

tampering with a camera.

transaction made using hardware at a customer’s facility

use/misuse of View to connect to or disconnect from a site.

use/misuse of Clear storage or Synchronize time by operator or Multi SA

use/misuse of an onsite device by a View operator ex.: locking a gate at a site, by remote control

use/misuse of an onsite device by a View operator. ex.: unlocking a gate at a site, by remote control

camera disabled by View operator

use/misuse of Reboot command

power failure or catastrophic failure of unit

failure of unit’s video hardware

failure of network or network’s time server

warning of imminent failure of storage

*Some events are repeated in the table: their source can vary. For example: an alarm triggered by an “Outside World event” can also be triggered by rebooting a unit.

† A Multi SA can set a Video lock event to be only logged rather than trigger an alarm.

‡ Some configuration settings can be changed onsite, using LocalView. These changes are not logged nor do they trigger an alarm when the configuration event is set tot do so.

190