System Administrator’s Guide

1.While adding or updating an account, click a box next to a right. See figure 9–3.Adding a checkmark adds the right to the account; remove the checkmark to remove the right.

2.To limit camera access, see To Limit Use of Cameras: Camera Partitioning on p. 183.

3.After modifying rights, users of Admin need to click Save and Close. Users of LocalView do not. If Central Management is enabled and the operator account will be used to operate the unit using View software and LocalView, then use View software to update security on the unit(s) to which the account will grant access. See Updating Security on a Multi-Media Unit, p. 131.

To Base Rights On Those of Another User

This feature is available in Admin only; not in LocalView.

1.Using Admin, click the User tab.

2.While updating or adding the account, click Rights and site access are based on.

3.Choose a user account from the list.

4.Click Save and Close.

User Rights and Security

In organizations with high security requirements

Your Multi SA can use Admin to provide operator accounts that:

1.limit the sites that a user can access. By default, access to all sites is granted. See Right to Access a Site on p. 182. You can set accounts to access only some sites.

2.limit the amount of time for use of a site. See Right to Access a Site, on p. 182.

LocalView

When using LocalView, there is no time limit to operating a unit.

To Deny Access

Denying access to sites is a security measure that is used against an operator who must be stopped from using Multi-Media units as soon as possible. The account data is preserved. For less severe cases, removing an account may be sufficient; see Removing a User's Account, p. 160.

Denying access to all Multi-Media units: Admin

1.Using Admin, click the Users tab.

2.Double-click the name of the account in the User Name column.

3.Click the box next to Deny this account access to sites [...] so that it shows a checkmark.

4.Click Save and Close.

5.Update security at each site listed in the “User can access selected sites” list. The procedure to update security is in section Updating Security on a Multi-Media Unit, on p. 131.

Document K14392V1 Rev A

159

07/07

 

Page 159
Image 159
Honeywell K14392V1 manual To Deny Access, To Base Rights On Those of Another User, User Rights and Security