Honeywell K14392V1 manual Programming a PTZ Dome Camera, To Configure a Preset on a PTZ Camera

System Administrator’s Guide

•To pan or tilt, move the mouse through the PTZ camera’s window until the pointer changes to a numbered arrow. Click. Figure 6–5shows the Zonal Mode for panning left. For continuous panning or tilting, click the arrow furthest from the center.

•To stop continuous panning or tilting, move the mouse through the PTZ camera’s window until the pointer changes to an octagon. Click.

•To zoom, use the wheel on the mouse. If the mouse does not have a wheel, see Using the Dartboard Control, above

Programming a PTZ Dome Camera

Fig. 6–6. PTZ Dome Camera without Auto-focus (1) or with, Between the Dots (2).

PTZ preset

Presets are set during a Maintenance Session. A PTZ camera can be set to return to the first preset when use of the camera ceases, when a Live session ends.

Auto-focus

View supports an auto-focus control when two dots appear in the “– Focus +” arc of the PTZ controller. Click between the dots to toggle auto-focus ON/OFF. See figure 6–6.

Auto-iris

View supports an auto-iris control when two dots appear in the “– Iris +” arc of the PTZ controller. Click between the dots to toggle auto-iris ON/OFF.

To Configure a Preset on a PTZ Camera

1.Continue or start a Maintenance Session.

2.Click the Video tab.

3.Click PTZ.

4.Select a camera whose PTZ preset you need to set.

Document K14392V1 Rev A	91
07/07