Honeywell K14392V1 manual Setting a Dial-Up Connection, Automatic Tag Added to a Connections Name

System Administrator’s Guide

Setting a Dial-Up Connection

Fig. 3–3. Automatic Tag Added to a Connection's Name.

1.While adding a site (as in Naming / Renaming a Site, above) or updating one, click in the “Connections to the Site” pane. The Add Connection dialog box is displayed. Leave the IP Address box empty for a dial-up connection to a Multi-Media unit.

2.Click Use Dial-up Networking. See figure 3–3, above. Admin automatically names the connection in the Connection Name box from “-> Network" to “-> Dialup”. See fig. 3–3.You have the option of keeping the name or of typing another.

3.Leave the Country Code to “(dialing same country)”, unless the Multi-Media unit is in a different country than the View operator planning to use the site.

4.Type the unit’s Area Code (City Code) and Phone Number obtained from your network administrator (this is mentioned in section Preparations, on p. 23). If a prefix number is needed to access an outside line, set the prefix—the extra telephone keystroke such as a “9” or an “8”—in Window's Telephony program.

5.Click Save and Close. An “Add Site / Update Site” window is displayed.

6.Click Close. The Sites tab appears. In the tab’s Primary Connection column, the first letter of “dial-up” appears in parentheses: (d), followed by the telephone number used to connect to the Multi-Media unit.

Should you plan to add alarm stations, dial-up connections from a Multi-Media unit to an alarm station are explained in section Dial-up Connection to an Alarm Station, on p. 208.

Document K14392V1 Rev A	31
07/07