Honeywell K14392V1 manual Testing a Preset Tour on a RapidDome Camera, Privacy Zones for RapidDome

Pan, Tilt, and Zoom (PTZ) Setup

Fig. 6–12. Location of the Program Vector Button.

Testing a Preset Tour on a RapidDome Camera

1.While using View, select the site at which you have programmed a Preset Tour on a RapidDome camera, as shown in procedure To Setup a Tour of Presets on a RapidDome Camera.

2.Run a Maintenance Session; click the Video tab.

3.Select the dome camera that is programmed with a Preset Tour.

4.Click PTZ. Check if the Driver is “RapidDome/Orbiter”. If not, the wrong camera or site may have been selected in step 1 and the remaining steps in this procedure cannot be used.

5.In the “Tour Programming” section, click Preset Tour (Vector).

6.Select the preset tour that you plan to test. To do so, click the arrow button above Dwell Time. A list appears, showing “Vector 1, Vector 2, Vector 3 …” by default. Click the name that you need.

7.Click Test.

Privacy Zones for RapidDome

Fig. 6–13. Setting Up a Privacy Zone on a RapidDome PTZ Camera.

PTZ preset 100 to 127 can be toggled to not display or to display the video feed coming from the RapidDome, when the dome is in the preset’s angle and zoom.

•Reset All. To cancel the privacy applied to presets, click Reset All. A confirmation dialog box appears. Click Yes.

To Set a Privacy Zone

Select the box next to the preset name so that it shows a check-mark. See figure 6–13, above, and figure 6–10–(4), on page 95. Remove the checkmark to enable Live and recoded video from that PTZ preset.

98