Network configuration

You might need to configure certain network parameters on the printer. You can configure these parameters from the printer control panel, the embedded Web server, or for most networks, from the HP Web Jetadmin software.

NOTE For more information about using the embedded Web server, see Using the embedded Web server.

For a complete list of supported networks and for instructions on configuring network parameters from software, see the HP Jetdirect Embedded Print Server Administrator’s Guide. The guide comes with printers in which an HP Jetdirect embedded print server is installed.

Manually configuring TCP/IP parameters from the printer control panel

Use manual configuration to set an IP address, subnet mask, and default gateway.

Setting an IP address

1.Press Menu.

2.Press to highlight CONFIGURE DEVICE, and then press .

3.Press to highlight I/O, and then press .

4.Press to highlight EMBEDDED JETDIRECT, and then press .

5.Press to highlight TCP/IP, and then press .

6.Press to select CONFIG METHOD.

7.Press to highlight MANUAL, and then press .

8.Press to highlight MANUAL SETTINGS, and then press .

9.Press to highlight IP Address:, and then press .

10.Press the or arrow to increase or decrease the number for the first byte of the IP address.

11.Press to move to the next set of numbers. (Press to move to the previous set of numbers.)

NOTE To cycle through the numbers faster, hold down the arrow button.

12.Repeat steps 10 and 11 until the correct IP address is entered, and then press to save the setting.

13.Press Menu to return to the Ready state.

Setting the subnet mask

1.Press Menu.

2.Press to highlight CONFIGURE DEVICE, and then press .

3.Press to highlight I/O, and then press .

ENWW

Network configuration 45

Page 59
Image 59
HP 3800, 3000 manual Network configuration, Setting an IP address, Setting the subnet mask