HP 4600hdn 4600n manual Output is curled or wrinkled, 176

Output is curled or wrinkled

You are printing large, solid-filled areas.

Large, solid-filled areas can cause excessive curl. Try using a different pattern.

Media used was not stored correctly and	Remove media and replace it with media from
may have absorbed moisture.	a fresh, unopened package.
Media has poorly cut edges.	Remove media, flex it, rotate it 180 degrees or
	turn it over, and then reload it into the input
	tray. Do not fan media. If the problem persists,
	replace the media.

The specific media type was not configured for the tray or selected in the software.

Configure the software for the media (see the software documentation). Configure the tray for the media, see Configuring input trays.

Printer will not duplex or duplexes incorrectly

Cause Solution

You are trying to duplex on unsupported media.

Verify that the media is supported for duplex printing. See Supported media weights and sizes.

The printer driver is not set up for duplex	Set up the printer driver to enable duplex
printing.	printing.
The first page is printing on the back of	Load preprinted forms and letterhead in Tray 1
preprinted forms or letterhead.	with the letterhead or printed side up and the
	bottom of the page feeding into the printer.
	For Tray 2 or Tray 3, load these media printed
	side down with the top of the page toward the
	back of the printer.

176 ENWW