HP 5100tn, 5100dtn manual Control Panel Menus B-5

Paper Handling Menu (Continued)

Item	Values	Explanation
MANUAL FEED=OFF	OFF	Feed the paper manually from Tray 1, rather
	ON	than automatically from a tray. When
		MANUAL FEED=ON and Tray 1 is empty, the
		printer goes offline when it receives a print job
		and displays MANUALLY FEED [PAPER
		SIZE].
		For more information, see page 42.
DUPLEX=OFF	OFF	This item appears only when an optional
	ON	duplexer is installed. Set the value to ON to print
		on both sides (duplex) or OFF to print on one
		side (simplex) of a sheet of paper.
		For more information, see page 33.
BINDING=	LONG EDGE	This item appears only when an optional
LONG EDGE	SHORT EDGE	duplexer is installed and the duplex option is
		on. Choose the binding edge when duplexing
		(printing on both sides of paper).
		For more information, see page 33.
OVERRIDE A4/	NO	Choose YES to print on letter size paper when
LETTER=NO	YES	an A4 job is sent, but no A4 size paper is loaded
		in the printer (or to print on A4 size paper when
		a letter job is sent, but no letter paper is loaded
		in the printer).
CONFIGURE FUSER	NO	Configure the fuser mode associated with each
MODE MENU=NO	YES	paper type. (This is only necessary if you are
		experiencing problems printing on certain
		paper types.)
		NO: The fuser mode menu items are not
		accessible.
		YES: Additional items appear (see below).
		Note
		To see the default fuser mode for each paper
		type, select YES, scroll back to the Information
		Menu, and print a menu map (page B-3).
[TYPE]=	NORMAL	This item appears only when CONFIGURE
NORMAL	LOW	FUSER MODE MENU=YES. Most paper types
	HIGH	are set to NORMAL by default.
		The exceptions are as follows:
	VELLUM
		ROUGH=HIGH
		VELLUM=VELLUM
		For a complete list of supported paper types,
		see page A-5.

ENWW Control Panel Menus B-5