HP 5Si NX, 5Si MX manual T e

5Load up to 2000 sheets of paper into the tray; do not allow paper to extend above the paperfill mark on the sides.

N o t e

For single-sided printing on Letter or A4 paper, place paper into Tray 4 with the side-to-be-printed down. Letterhead should be oriented to the rear of the tray. Load 3-hole paper with holes on your right. For two-sided printing, place paper with the front side (odd-numbered) up. The back side (even-numbered) is printed first, and the front side is printed second. Letterhead should be oriented to the rear of the tray. Load 3-hole paper with holes on your left.

For single-sided printing on 11 x 17 in, Legal, A3, or JIS B4, place paper into the tray with the side-to-be-printed down. For two-sided printing, place paper with the front side (odd-numbered) up. The back side (even-numbered) is printed first, and the front side is printed second.

6Press down on all four corners of the paper stack to ensure the paper rests flat in the tray, without bending the paper.

7Close Tray 4.

8Ensure that the paper size tab is set correctly.

5Print Tasks

N o t e

See “Changing Paper Type and Size from the Control Panel” later in this chapter to set the type of paper you loaded in the tray.

If using the Top Output Bin, remember to adjust the paper stop guide on the output bin (see Figure 5-4).

EN

Print Tasks 5-15