HP 5Si NX, 5Si MX Printing to the Multibin Mailbox or Mailbox with Stapler, Through the Software

Printing to the Multibin Mailbox or Mailbox with Stapler

The optional Multi-Bin Mailbox or Mailbox with Stapler can work in one of three modes: mailbox mode, job separation mode, or stacking mode. The network or printer administrator determines which mode of operation is chosen through an HP network configuration utility, such as HP JetAdmin or HP LaserJet Utility. You need to set up your printer driver to reflect the mode chosen by the administrator. Bidirectional environments automatically reflect the administrator’s choices in your printer driver.

The printer control panel displays different names for the mailboxes and stapler, depending on which mode the driver is using.

In Mailbox Mode, if the	Then the physical
Control Panel says:	location is:
OPTIONAL OUTPUT BIN 1	Left Output Bin
OPTIONAL OUTPUT BIN	Mailbox 1-5
2 through 6
OPTIONAL OUTPUT BIN X	Stapler Bin

(X represents any number other than 1 through 6.)

In Job Separation or
Stacking Modes, if the	Then the physical
Control Panel says:	location is:
OPTIONAL OUTPUT BIN 1	Top Output Bin
OPTIONAL OUTPUT BIN 2	Mailbox bins
OPTIONAL OUTPUT BIN X	Stapler Bin

(X represents any number other than 1 through 6.)

	Selecting the Multi-Bin Mailbox or Mailbox with Stapler
	through the Software
	You can select these output bins through your software application,
	printer driver, or from the printer control panel. It is better to designate
	the paper destination in your software or printer driver since you will
	control to which output bin your job is sent. Otherwise, follow the
	instructions below for setting the overall default output bin selection.
	Where and how you make selections depends on your software
N o t e
	application or associated printer driver. The selection process may be
	available only from within the printer driver. See Chapter 3 or your
	application manual for more information.

5Print Tasks

EN

Print Tasks 5-27