HP 5Si MX, 5Si NX manual Printer Messages, Message Description Recommended Action

Printer Messages

Table 7-2 lists and describes printer messages and suggests recommended actions.

Printer Messages

Message	Description	Recommended Action
READY	The default ready message. The	No action required.
	printer is ready to use.
OFFLINE	The printer is offline and cannot	Press [On Line].
	print data.
WARMING UP	The printer is warming up and is	Wait until the printer signals
	not ready to accept data.	READY.
POWER SAVE ON	The printer is in Power Save mode.	No action required. The job
	In Power Save mode all control	prints when the fuser has
	panel keys operate normally. (See	warmed (about 45 seconds).
	“Configuration Menu” in Chapter 4.)
PERFORM USER	This message indicates that the	Purchase a maintenance kit
MAINTENANCE	printer requires routine	and install the new parts. Then
	maintenance. It will replace the	remove the message by
	READY message until it is cleared.	turning SERVICE MESSAGE=
		OFF in the CONFIGURATION
		MENU.
PRINTING	The printer is printing a	No action required.
CONFIGURATION PAGE	configuration page.
PRINTING FONT LIST	The printer is printing a font list.	No action required.
	(Note that PCL/PostScript formats
	are the same.)
PRINTING DEMO PAGE	The printer is printing a	No action required.
	Demonstration Page.
COPY XX OF YY from	This message indicates the	No action required.
Tray n	progress of the current job.
INTERNAL TEST	The printer is conducting a test of	No action required.
	its components.
PROCESSING JOB FROM	The printer is working on a job	No action required.
TRAY n	from the indicated tray.
TRAY n LIFTING	The printer is lifting the paper tray	No action required.
	to its working position after paper
	was loaded.

Continued on the next page.

7-36 Maintenance and Troubleshooting

EN