HP 5Si MX, 5Si NX Stapling Documents, Selecting the Stapler through the Software, Control Panel

Selecting the Multi-Bin Mailbox or Mailbox with Stapler as default destination from the Control Panel

1Press [Menus] repeatedly until CONFIGURATION MENU appears.

2Press [Items] repeatedly until PAPER DESTINATION= TOP OUTPUT BIN * appears.

3Press [+] repeatedly until PAPER DESTINATION= OUTBIN x appears. The x represents a number from 1–7 (for the output bins). Your network administrator may have changed these names.

4Press [Select *] to save your choice. An asterisk (*) appears next to your selection.

	Stapling Documents
	The stapler can staple documents of 2 to 20 pages on 16 lb. to 20 lb.
	bond paper, Letter and A4 size only. The stapler should not be set as the
	default output bin. If your job is only one page, or if it is greater than 20
	pages, the printer will print your job to the bin, but it will not be stapled.
	The stapler bin can hold up to 350 stapled sheets. To have your job
	stapled, send it to OPTIONAL OUTBIN 7.
	Selecting the Stapler through the Software
	You can select the stapler through your software application or printer
	driver. This is the recommended method for stapling. If you are unable
	to designate the paper destination in your software or printer driver,
	follow the instructions below for setting the overall default printer
	output bin selection.
	Where and how you make selections depends on your software
N o t e
	application or associated printer driver. The selection process may be
	available only from within the printer driver. See Chapter 3, “Printer
	Software,” or your application manual for more information.
	Selecting the Stapler as default destination from the
	Control Panel
	If your software does not support stapling, set it using the directions
	below.

1Press [Menus] repeatedly until CONFIGURATION MENU appears.

2Press [Items] repeatedly until PAPER DESTINATION= TOP OUTPUT BIN * appears.

5-28 Print Tasks

EN