Technical Reference Guide
5.2.2 IDE CONNECTOR
This system uses a standard
Figure 5-1. 40-Pin Primary IDE Connector (on system board).
Table 5–3. 40-Pin Primary IDE Connector Pinout
Table
40-Pin Primary IDE Connector Pinout
Pin | Signal | Description | Pin | Signal | Description |
1 | RESET- | Reset | 21 | DRQ | DMA Request |
2 | GND | Ground | 22 | GND | Ground |
3 | DD7 | Data Bit <7> | 23 | IOW- | I/O Write [1] |
4 | DD8 | Data Bit <8> | 24 | GND | Ground |
5 | DD6 | Data Bit <6> | 25 | IOR- | I/O Read [2] |
6 | DD9 | Data Bit <9> | 26 | GND | Ground |
7 | DD5 | Data Bit <5> | 27 | IORDY | I/O Channel Ready [3] |
8 | DD10 | Data Bit <10> | 28 | CSEL | Cable Select |
9 | DD4 | Data Bit <4> | 29 | DAK- | DMA Acknowledge |
10 | DD11 | Data Bit <11> | 30 | GND | Ground |
11 | DD3 | Data Bit <3> | 31 | IRQn | Interrupt Request [4] |
12 | DD12 | Data Bit <12> | 32 | IO16- | |
13 | DD2 | Data Bit <2> | 33 | DA1 | Address 1 |
14 | DD13 | Data Bit <13> | 34 | DSKPDIAG | Pass Diagnostics |
15 | DD1 | Data Bit <1> | 35 | DA0 | Address 0 |
16 | DD14 | Data Bit <14> | 36 | DA2 | Address 2 |
17 | DD0 | Data Bit <0> | 37 | CS0- | Chip Select |
18 | DD15 | Data Bit <15> | 38 | CS1- | Chip Select |
19 | GND | Ground | 39 | HDACTIVE- | Drive Active (front panel LED) [5] |
20 | Key | 40 | GND | Ground |
NOTES:
[1]On UATA/33 and higher modes,
[2]On UATA/33 and higher mode reads,
[3]On UATA/33 and higher mode reads,
[4]Primary connector wired to IRQ14, secondary connector wired to IRQ15.
[5]Pin 39 is used for spindle sync and drive activity (becomes
Compaq D315 and hp d325 Personal Computers
Featuring the AMD Athlon XP Processor
Second Edition - April 2003