HP J5788, J5780, J5750, J5740 manual Solution Use photo paper to make borderless copies

Chapter 12

Solution: Use photo paper to make borderless copies.

To make a borderless copy of a photo from the control panel

1.Load 10 x 15 cm (4 x 6 inch) photo paper in the input tray.

2.Load your original photo print side down on the right front corner of the glass. Position the photo on the glass so the long edge of the photo is along the front edge of the glass, as indicated by the engraved guides along the edge of the glass.

3.Press Start Copy Black or Start Copy Color.

The HP All-in-One makes a 10 x 15 cm (4 x 6 inch) borderless copy of your original photo.

NOTE: If you loaded tabbed paper in the photo tray, you can remove the tab from the copy of your photo once the ink has completely dried.

TIP: If the output is not borderless set the paper type to Premium Photo, and then try making the copy again.

Cause: Debris might be stuck on the glass or on the back of the document lid. The HP All-in-One interprets anything it detects on the glass as part of the image.

Solution: Turn off the HP All-in-One, unplug the power cord, and then use a soft cloth to wipe the glass and the back of the document lid.

To clean the glass

1.Turn off the HP All-in-One, and raise the lid.

2.Clean the glass with a soft cloth or sponge slightly moistened with a nonabrasive glass cleaner.

CAUTION: Do not use abrasives, acetone, benzene, or carbon tetrachloride on the glass, since they can damage it. Do not place or spray liquid directly on the glass. The liquid might seep under the glass and damage the device.

230 Troubleshooting