HP R-2A, R-2 MD01, R-3A, R-2 RDR manual Or for the RPC-2A

RPC SERIES OWNER’S MANUAL

RPC SERIES QUICK START (RPC-2 AND RPC-2A)

________________________________________________________________________________

If the status menu fails to appear, ensure the correct cables and adapters are being used and that they are connected properly. Also, verify the serial communication parameters are correctly configured.

Controlling Receptacles To set or change the status of the receptacles, enter one of the following commands: ON n, OFF n, REBOOT n, where “n” is the outlet number you want to command. Entering an outlet number of “0” sends the command to all outlets. Reboot only works on outlets which are in the “ON” condition.

CONFIGURATION Type “CONFIG” from the RPC> prompt. The following menu appears:

For the RPC-2:

RPC >CONFIG

1). . . Change Password

2). . . Change Outlet Name Enter Request:

Or for the RPC-2A:

RPC > CONFIG

1). . . Change Password

2). . . Change Outlet Name

3). . . Enable/Disable Confirmation

4). . . Enable/Disable Status Menu

X). . . Exit Enter Request:

3