HP R-2 RDR, R-2A, R-2 MD01, R-3A manual Detailed Operation and Configuration

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

RPC-2 Series

(c)1997 by BayTech

F2.07

Circuit Breaker : On

1) . . . OUTLET 1	: Off
2) . . . OUTLET 2	: Off
3) . . . OUTLET 3	: On
4) . . . OUTLET 4	: Off
5) . . . OUTLET 5	: Off
6) . . . OUTLET 6	: Off
RPC >

Likewise, typing ON 0 at the RPC > prompt and responding “Y” for yes, turns “On” all outlets. Typing OFF n at the RPC > prompt turns off corresponding outlet(s).

The REBOOT n command will reboot or reset equipment attached to corresponding receptacle(s). When the command to REBOOT (n) is sent from the RPC > prompt, the RPC powers “Off” corresponding outlet(s) for approximately 10 seconds, then powers them up in sequence. This command only works on outlets which were “On” prior to the reboot.

CONFIGURATION The RPC-2’s configuration menu allows the user to (1) set or change a password and (2) customize the outlet name(s) to identify equipment attached to the RPC. In addition to “Change Password” and “Change Outlet Name,” the RPC-2A’s configuration menu allows enabling/disabling confirmation and enabling/disabling status menu.

The password is disabled from the factory by making the password a carriage return. If a password (other than a carriage return) is

22