HP R-2A, R-2 MD01, R-3A RPC-3, RPC-3A and RPC-5 Quick Start, Remote access using, Network port

RPC SERIES OWNER’S MANUAL

RPC SERIES QUICK START (RPC-3, RPC-3A, AND RPC-5)

________________________________________________________________________________

RPC-3, RPC-3A AND RPC-5 QUICK START

NOTE: The RPC-3, 3A and 5 are configured in a similar manner. This quick start will reference the RPC-3 menus. The only programming differences for the RPC-5 pertain to the number of receptacles shown in the menus (4 vice 8).

NOTE: Inlet #1 supplies power to the logic of the RPC-5, this inlet must have power for the unit to operate.

Local access	Using the 9FRJ45PC-1 adapter and the
using EIA-232 serial	RJ08X007 (8-pin crossed) cable, connect the
connection	serial port of your computer to the RJ-45
	port labeled “EIA-232” on the RPC unit.
Remote access using	Using a straight 10Base-T cable, connect
network port	the port labeled Ethernet on the RPC to the
connection	network hub. Establish a Telnet client
	session and login from your workstation.
	Load serial port communications software. Set
	serial communications parameters to 9600
	bps, 8 data bits, 1 stop bit, and no parity.
OPERATION
Accessing Main Menu	Power on the RPC unit. The following main
	menu appears:

8