HP R-2A, R-2 MD01, R-3A, R-2 RDR manual Remote Access Using Modem Connections, RPC-2 MD01

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

parameters are 9600 bps, 8 data bits, 1 stop bit, and no parity.

REMOTE ACCESS

USING MODEM

CONNECTIONS

RPC-2 MD01	Using the RJ04X007 (RJ-11) modular cable,
(Internal Modem)	connect either port labeled “LINE” on the
	back of the RPC unit to the telco wall jack.
RPC-2 RDR	Plug the modem’s power supply into
(External Modem)	receptacle number six on the RPC. Using the
	RJ04X007 (RJ-11) modular cable, connect
	either port labeled “LINE” on the back of
	the RPC unit to the telco wall jack. Using
	another RJ04X007 (RJ-11) modular cable,
	connect the remaining port labeled “LINE”
	on the back of the RPC unit to the port
	labeled “LINE” on the external modem.
	(See Figure 1 on page 5.)
	Using the 25MRJ45MD-8 adapter and the
	RJ08X007 (8-pin crossed) cable, connect the
	DB-25 female port of the modem to the RJ-
	45 port labeled “EIA-232” on the back of
	the RPC unit.

IMPORTANT: You must customize the external modem’s configuration to operate properly with the RPC-2 RDR. See Appendix C (MODEM COMMAND SUMMARY) for information on customizing external modem configurations.

28