RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
If the status menu fails to appear, ensure the correct cables and adapters are being used and that they are connected properly. Also, verify the serial communication parameters are correctly configured.
Controlling Receptacles | To set or change the status of receptacles, |
| enter one of the following commands: ON |
| n, OFF n, REBOOT n, where “n” is the |
| outlet number you want to command. |
| Entering an outlet number of “0” sends the |
| command to all outlets. |
Example: | To turn “On” Outlet 3, type ON 3 from the |
| RPC prompt (RPC >). The RPC responds: |
| Turn On Outlet 3 (Y/N)? |
| Responding “Y” for yes turns “On” Outlet 3. |
| Observe that the status of Outlet 3 has |
| changed to On in the status menu: |
(c)1997 by BayTech
F2.07
Circuit Breaker : On
1) . . . OUTLET 1 | : Off |
2) . . . OUTLET 2 | : Off |
3) . . . OUTLET 3 | : On |
4) . . . OUTLET 4 | : Off |
5) . . . OUTLET 5 | : Off |
6) . . . OUTLET 6 | : Off |
RPC > |
|
Likewise, typing ON 0 at the RPC > prompt and responding “Y” for yes, turns “On” all outlets. Typing OFF n at the RPC > prompt turns off corresponding outlet(s).
30
