RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
Enter the Gateway address (Example: 200.4.5.50), followed by <cr>. The RPC resumes the configuration menu Default Gateway address is 0.0.0.0. If you fail to enter the Gateway address is dotted decimal form, the RPC responds again:
| Enter Gateway address in dotted decimal form: |
| The RPC responds indefinitely with the |
| same request until the Gateway address is |
| entered in the correct form. |
Unit ID | From the configuration menu, select #4, |
| “Unit ID.” The RPC responds: |
| Enter Unit ID (64 chars max): |
| Enter the RPC Unit ID, followed <cr>. The |
| RPC resumes the configuration menu. |
| Default Unit ID is |
Access | Login Setup allows the user to enable or |
| disable username and password login for |
| both serial and network ports. If the features |
| are enabled, the RPC requires username and |
| password entry before allowing access to the |
| unit. |
| To configure the login setup, select #5, |
| “Access,” from the configuration menu, |
| followed by <cr>. The RPC Series responds |
| with the following Login Setup menu: |
49
