System Messages

Action: Delete unnecessary files from the hard disk.

DOSCLINST-1.0-3: The INSTALL.OVL file could not be found.

Explanation: The INSTALL.OVL file could not be found. This file is an integral piece of the INSTALL utility; it must be in the same directory as the INSTALL.EXE file.

Action: Make sure that INSTALL.OVL is in the same directory as the INSTALL.EXE file; then run INSTALL again.

DOSCLINST-1.0-4: A read error occurred while the program was reading INSTALL.OVL.

Explanation: The file INSTALL.OVL has been corrupted. The INSTALL utility requires INSTALL.OVL for successful installation.

Action: Copy INSTALL.OVL from the master diskettes to the same directory as the INSTALL.EXE file; then run INSTALL again.

FIO-1.00-1: The message file <name> is invalid. The program cannot be loaded.

Explanation: The .MSG file is invalid. This problem could be the result of a corrupted file, a bad translation, or an outdated file version.

Action: Either update the .MSG file with a valid copy or delete the file. The NetWare® DOS Requester™ software uses the default messages that are bound to the binary files.

FIO-1.00-5: <Module1>.VLM is not loaded. The <module2>.VLM file cannot be loaded before <module1>.VLM. Load the <module1>.VLM file first then try to load the <module2>.VLM file.

Explanation: The <module2>.VLM file requires that the <module1>.VLM file be loaded first. Either the current configuration has <module1>.VLM and <module2>.VLM loading out of order, or <module1>.VLM did not load successfully.

Action: Make sure that <module1>.VLM is configured to load before <module2>.VLM. To do this, change the load order of the VLM= parameter in the NET.CFG file.

FIO-1.00-7: In order to load the <module3>.VLM, one of the followingVLMs must be loaded: <module1>.VLM, <module2>.VLM.

4-8