HP UX Internet and Networking Software TCP/IP Groups, Example of NET.CFG File Including Each Group Support

NOTE:

NOTE:

NET.CFG Options Reference

Desktop SNMP Option

Always place the vlm=mib2if.vlm line after the lines that load the Desktop SNMP VLM suite of files.

TCP/IP Groups

Desktop SNMP also provides a separate VLM file, MIB2PROT.VLM, that supports the TCP/IP groups (all groups except interface, system, and SNMP, which are supported by other VLM files, and EGP and transmission, which are not supported).

Load this VLM when you are using the TCP/IP stack from LAN WorkPlace® software.

Add the following lines to the NET.CFG file:

netware dos requester

vlm=mib2prot.vlm

Always place the vlm=mib2prot.vlm line after the lines that load the Desktop SNMP VLM suite of files.

Example of NET.CFG File Including Each Group Support

On a workstation where the NetWare DOS Requester™ and comprehensive MIB-II support are both loaded, the entire Netware DOS Requester and Desktop SNMP sections of your NET.CFG file might read as follows:

netware dos requester vlm=wssnmp.vlm vlm=wstrap.vlm vlm=wsreg.vlm vlm=wsasn1.vlm vlm=mib2if.vlm vlm=mib2prot.vlm

desktop snmp

sysname “Suzanne Morley x893” syslocation “Building 2” syscontact “Suzanne@acompany.com” snmpenableauthentraps on

2-26