NET.CFG Options Reference
Link Driver Option
If the IBM LAN Support driver’s DXMT0MOD.SYS file is to load in the CONFIG.SYS file, one of two actions must be performed:
1Set “o=n” on the command line for loading the DXMT0MOD.SYS file in the CONFIG.SYS file and use this parameter in the NET.CFG file.
2Set “o=y” on the command line to load the DXMT0MOD.SYS file and set the frame size for the NDIS driver. Do not use this parameter in the NET.CFG file.
PORT [#1 #2] hex_starting_address [hex_number_of_ports]Specifies the starting port (hex_starting_address) and number of ports in the range (hex_number_of_ports).
Syntax | port [#1 #2] hex_starting_address |
| [hex_number_of_ports] |
| All values must be written in hexadecimal |
| notation. |
|
|
Default | #1 |
|
|
Example | If the starting I/O port on an NE2100 LAN driver is 300 |
| and 16 ports are in the first range, you would place the |
| following lines in your NET.CFG file: |
| link driver ne2100 |
| port 300 16 |
| To specify two ranges with 32 ports in each range, you |
| could place the following lines in your NET.CFG file: |
| link driver ne2100 |
| port #1 300 32 |
| port #2 340 32 |
|
|