NET.CFG Options Reference
Link Driver Option
Link Driver Option
Use this option to specify the hardware and software configurations of the LAN drivers for each network board in your workstation.
The value settings you specify for each parameter with this option should match the hardware and software settings for your network board.
This option also allows you to set up the proper frame type and protocols for NetWare supported LAN drivers.
Available Parameters and Values for the Link Driver Option
This option has the following parameters and values.
Parameters and Values
ALTERNATE
BUS ID name number
DMA [#1 #2] channel_number
FRAME frame_type_name [addressing_mode]
IRQ [#1 #2] interrupt_request_number
MAX FRAME SIZE number
MEM [#1 #2] hex_starting_address [hex_length]
NODE ADDRESS hex_address [mode]
PORT [#1 #2] hex_starting_address [hex_number_of_ports]
PROTOCOL “name” hex_protocol_ID frame_type
SAPS number
SLOT number
LINK DRIVER driver_name
Specifies the LAN driver you are making configurations for.