System Messages

Explanation: The configuration file contains a parameter that is defined to use either an ON or OFF value, but a different value or no value has been specified. This invalid line is ignored by the configuration process.

Action: No action is required at this point. However, to avoid this message the next time the VLM.EXE file is loaded, delete or correct the line specified by the error message.

IPXNCP-1.00-45: The parameter specified for the following option was out of range and has been adjusted.

Explanation: A configurable parameter has been configured too high or too low to be valid. The parameter is specified on the line following the message.

Action: Check and correct the parameter specified in the NET.CFG file. See Chapter 2, “NET.CFG Options Reference,” for more information.

IPXNCP-1.00-53: The IPX interface is not loaded. The IPXNCP.VLM file cannot be loaded. Load the IPXODI.COM file first and then try loading the IPXNCP.VLM file.

Explanation: An attempt was made to load the IPXNCP.VLM file without having previously loaded the IPX™ interface.

Action: Load the IPXODI.COM file before attempting to load

IPXNCP.VLM.

IPXNCP-1.00-54: The IPX sockets could not be opened. The IPXNCP.VLM file cannot be loaded. Configure the IPXODI.COM file for enough sockets in the NET.CFG file and then try to load the IPXNCP.VLM file.

Explanation: The IPXNCP.VLM file failed to open the IPX™ sockets needed in order to run. The IPXNCP.VLM file requires that four or more IPX sockets be available to run.

Action: Increase the number of IPX sockets available by using the IPX SOCKETS= parameter in the NET.CFG file; then reload the IPXODI.COM and IPXNCP.VLM files.

4-15