System Messages

FIO-1.00-60: Too much cache is configured. The FIO.VLM file will reduce the cache blocks by <number> blocks and load successfully. Check the CACHE BUFFERS and BUFFER SIZE parameters in the NET.CFG file; then load the FIO.VLM file.

Explanation: The amount of cache available in DOS is limited by conventional memory. Neither of the parameters determining the amount of memory to be used, CACHE BUFFERS nor BUFFER SIZE, can be configured to use more than 64 KB of memory.

Action: Reduce the CACHE BUFFERS or BUFFER SIZE parameter in the NET.CFG file. See Chapter 2, “NET.CFG Options Reference,” for more information.

FIO-1.00-61: The IPX interface is not loaded. The FIO.VLM file will load successfully without packet burst support. Load the IPXODI v2.00 or later to use packet burst or add PB BUFFERS=0 to the NET.CFG file; then load FIO.VLM.

Explanation: This message is only a warning. The NetWare® DOS Requester™ software functions properly without the use of the Packet Burst™ protocol. Packet Burst, which is a part of the FIO.VLM file, requires IPXODI.COM version 2.00 or later to function properly. No IPX™ interface was loaded in this machine.

Action: If you want Packet Burst, make sure that IPXODI.COM version

2.00or later is loaded before the NetWare DOS Requester. If you do not want Packet Burst, add PB BUFFERS=0 to the NetWare DOS Requester section of the NET.CFG file. See See Chapter 2, “NET.CFG Options Reference,” for more information.

FIO-1.00-62: The LSL interface is not loaded. The FIO.VLM file will load successfully without packet burst support. Load the LSL module or add PB BUFFERS=0 to the NET.CFG file; then load FIO.VLM.

Explanation: This message is only a warning. The NetWare® DOS Requester™ software functions properly without the use of the Packet Burst™ protocol. Packet Burst, which is a part of the FIO.VLM file, requires the LSL.COM file to be loaded to function properly.

4-10