HP UX Internet and Networking Software 201

System Messages

SECURITY-1.00-42: There is a missing or invalid value for ‘<parameter>’ on line <number> of the conﬁguration ﬁle. This entry will be ignored. Correct the line speciﬁed in the conﬁguration ﬁle before continuing.

Explanation: The conﬁguration ﬁle contains a parameter that has an invalid value or that does not specify a value. This invalid line is ignored by the conﬁguration process.

Action: No action is required at this point. However, to avoid this message the next time the VLM.EXE ﬁle is loaded, delete or correct the line speciﬁed by the error message.

SECURITY-1.00-43: There is a missing or invalid ON/OFF value for ‘<parameter>’ on line <number> of the conﬁguration ﬁle. This entry will be ignored. Correct the line speciﬁed in the conﬁguration ﬁle before continuing.

Explanation: The conﬁguration ﬁle contains a parameter that is deﬁned to use either an ON or OFF value, but a different value or no value has been speciﬁed. This invalid line is ignored by the conﬁguration process.

Action: No action is required at this point. However, to avoid this message the next time VLM.EXE is loaded, delete or correct the line speciﬁed by the error message.

SECURITY-1.00-45: The parameter speciﬁed for the following option was out of range and has been adjusted.

Explanation: A conﬁgurable parameter has been conﬁgured too high or too low to be valid. The parameter is speciﬁed on the line following the message.

Action: Check and correct the parameter speciﬁed in the NET.CFG ﬁle. See Chapter 2, “NET.CFG Options Reference,” for more information.

SECURITY-1.00-67: The SECURITY.VLM ﬁle must be loaded before any other NetWare Protocol Module. The SECURITY.VLM ﬁle will not be loaded. Load the SECURITY.VLM ﬁle before loading any NetWare Protocol Modules.

4-29