System Messages

Explanation: The VLM™ programs for the NetWare® DOS Requester™ software have been improperly configured to include two programs with the same VLM ID. This can be caused by either a VLM being included twice in the VLM= parameter list, or by a VLM attempting to reuse a VLM ID assigned to a different VLM.

Action: Check the NET.CFG file for duplicates in the VLM list. Make sure that the USE DEFAULTS= parameter is set to OFF. See Chapter 2, “NET.CFG Options Reference,” for more information.

VLM-1.00-47: A file server could not be found. Check the network cabling and the server’s status before continuing.

Explanation: No NetWare® server was found when attempting to build an initial connection. This could be caused by any of the following:

•An improperly configured network board or LAN driver

•Improperly configured IPX™ software

•A disconnected network cable

•An attempt to load the NetWare DOS Requester™ software before a NetWare server has been initialized.

Try one or more of the following:

•Ensure that the network board and LAN driver are properly configured by checking the network board settings and the NET.CFG file settings.

See Chapter 2, “NET.CFG Options Reference,” for more information.

•Ensure that IPX is configured to be bound properly to the right LAN driver.

•Check the network cabling.

•Ensure that a NetWare server is up and running before attempting to load the NetWare DOS Requester.

VLM-1.00-60: There is an unrecognized entry ‘<entry>’ on line <number> of the configuration file. This entry will be ignored. Correct the line specified in the configuration file before continuing.

Explanation: The configuration file contains a parameter under a header where it does not belong. This invalid line is ignored by the configuration process.

4-38