Table 44 Path Status and Examples of the Recovery Procedure (USP V/VM)
Path Status | Examples of the Recovery Procedure | |
External device setting | Settings of the LU paths may have been changed by LUN Manager. Check the | |
changed | settings of the LU paths. If the settings of the LU paths have been changed, | |
| change the settings back to the ones when the volume is mapped. Or use XP | |
| External Storage to perform the Delete LU operation and perform the Add LU | |
| operation again. | |
| The access attribute of the volume may have been changed by Data Retention | |
| Utility. Check the access attribute of the volume. If the volume is protected by | |
| the access attribute, release the protection. | |
Illegal request or | The volume may have been set as a pair volume for data copy. Check if the | |
Response error | volume is set as a pair volume of XP Business Copy, XP Continuous Access, XP | |
Continuous Access Journal, or other copy program. If the volume is set as a | ||
| ||
| pair volume, the volume may be protected because of the pair status. When | |
| the volume is protected, change the pair status or delete the pair. | |
| The access attribute of the volume may have been changed by Data Retention | |
| Utility. Check the access attribute of the volume. If the volume is protected by | |
| the access attribute, release the protection. | |
Cannot detect port | There is a problem with the connection to the external storage system. The | |
| possible causes are: | |
| • The fiber cable is not physically connected in the proper way. | |
| • The setting of the topology does not match between the external port and | |
| the target port. | |
| • If the external storage system is connected through switches, the settings for | |
| the switches may not be appropriate. | |
| Make sure that the fiber cable is connected properly, and then set the Fibre | |
| Channel port properly using LUN Manager. | |
| The LUN security may have been enabled by LUN Manager. Check if the LUN | |
| security is enabled or not. If the LUN security is enabled, disable the LUN | |
| security. |
Lightning 9900V Storage System
When connecting a Lightning 9900V storage system as the external storage system, you need to set the port to the host group for the Windows hosts (host mode 0C: Windows, host mode 2C: Windows Extension).
Also, the port attribute must be the target port or the RCU target port.
Path Status and Examples of the Recovery Procedure
This section describes errors that require recovery operation on the external storage system side when the path status is not normal. When the path status is not normal, see Table 45 (page 144) to recover the path status. For other errors not described in this section, see “Troubleshooting for XP External Storage” (page 126). If you cannot restore the path, call HP technical support (see “Calling HP Technical Support” (page 131)).
