Table 50 System Parameter (Sun StorageTek FlexLine 380)

Parameter

Parameter Setting

 

 

host type

Windows Non-clustered (DMP Support)

 

 

Sun StorageTek 2540

When connecting a Sun StorageTek 2540 as an external storage system, set the system parameters of the Sun StorageTek 2540 according to Table 51 (page 148). For the system parameters that are not in Table 51 (page 148), see the documentation for the Sun StorageTek 2540 and set the parameters appropriately for the connecting configuration.

Table 51 System Parameter (Sun StorageTek 2540)

Parameter

Parameter Setting

 

 

host type

Windows 2K non Clustered DMP

 

 

Sun StorageTek V2X2

When connecting a Sun StorageTek V2X2 as an external storage system, make sure that only one cross-subsystem path is configured when you map external volumes. Do not add any alternate paths after you finish mapping external volumes.

EMC CLARiiON CX Series

When you connect an EMC CLARiiON CX series as an external storage system, set the system parameters of the EMC CLARiiON CX series according to the settings in Table 52 (page 148). For system parameters that are not in Table 52 (page 148), see the EMC CLARiiON CX series documentation and set the parameters appropriately to connect your configuration.

Table 52 System Parameters (EMC CLARiiON CX series)

Parameter

Parameter Setting

 

 

Initiator Type

CLARiiON Open

 

 

Failover Mode

2

 

 

Notes on Connecting an EMC CLARiiON CX Series

Volumes created with Individual Disk Units (JBOD disks) of EMC CLARiiON CX series are not supported.

The following restrictions are for the use of the RAID-6 volume for the EMC CLARiiON CX series. Moreover, when you downgrade a version of a storage system that does not support the RAID-6 volume from a version of a storage system that supports the RAID-6 volume, the configuration of the EMC CLARiiON CX series should be changed.

148 Connecting External Storage Systems