Select this choice to view information about the server. When you make changes through other choices in the Setup utility, some of those changes are reflected in the system information; you cannot change settings directly in the system information.
This choice is on the full Setup utility menu only.
–System Summary
Select this choice to view configuration information, including the ID, speed, and cache size of the microprocessors; machine type and model of the server; the serial number; the system UUID; and the amount of installed memory.
When you make configuration changes through other choices in the Setup utility, the changes are reflected in the system summary; you cannot change settings directly in the system summary.
–Product Data
Select this choice to view the
v System Settings
Select this choice to view or change the server component settings. This choice is on the full Setup utility menu only.
–Adapters and UEFI Drivers
Select this choice to view information about the adapters and device drivers in the server that are compliant with EFI 1.10 and UEFI 2.0.
–Processors
Select this choice to view or change the processor settings.
–Memory
Select this choice to view or change the memory settings. To configure memory mirroring, select System Settings → Memory → Memory Mirroring Mode → Mirrored.
–Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output (I/O) ports. You can configure the serial ports; configure remote console redirection; enable or disable integrated Ethernet controllers, the SAS/SATA controller, SATA optical drive channels, and PCI slots; and view the system Ethernet MAC addresses. If you disable a device, it cannot be configured, and the operating system will not be able to detect it (this is equivalent to disconnecting the device).
–Power
Select this choice to view or change power settings.
-Active Energy Manager
Select this choice to enable or disable power capping. If you enable power capping, the Active Energy Manager program will limit the maximum power that is consumed by the server.
-Power Restore Policy
Select this choice to determine the mode of operation to which the server will be restored after a power outage occurs. You can select Always on, Always off, or Restore to restore the server the state it was in at the time of the power outage.
–Operating Modes
Chapter 3. Configuring the server 97
