The following illustration shows the locations of the DIMM connectors on the system-board tray.

To install a DIMM (memory module) in the memory expansion module, complete the following steps.

Note: The memory expansion module might come with DIMM fillers on DIMM connectors that are not populated. Remove them before you install DIMMs in those connectors.

1.Read “Safety” on page v and “Installation guidelines” on page 38.

2.Turn off the host server (see “Turning off the server” on page 20) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables from the server. Disconnect all power cords; then, disconnect all external cables from the memory expansion module. (Do not bend or nick the scalability cables when working with the cables.)

3.Remove the bezel (see “Removing the bezel” on page 47).

4.Remove the system-board tray (see “Removing the memory expansion module system-board tray” on page 82).

5.Remove any DIMM fillers from the DIMM connectors that you want to populate.

Chapter 2. Installing optional devices 87

Page 101
Image 101
IBM 71453RU manual Installing optional devices