Completing the installation
To complete the installation, complete the following steps:
1.If you removed the front bezel, slide the bezel onto the front of the server chassis.
2.If you removed the
3.Place the top cover over the top of the server.
4.Slide the top cover forward; then, press down on the cover handle until it clicks into place.
5.Connect the cables and power cords to the rear of the server. For more information, see “Connecting the cables.”
6.Start the server. Confirm that it starts correctly and recognizes the newly installed devices, and make sure that no error LEDs are lit.
7.(IBM Business Partners only) Complete the additional steps in “Instructions for IBM Business Partners” on page 29.
Connecting the cables
Notes:
1.Be sure to turn off the server before you connect any cables to or disconnect any cables from the server.
2.Detailed cabling information is available in the Rack Installation Instructions that came with your server or the Installation Instructions that came with any cable kits.
3.For additional cabling instructions, see the documentation that comes with the optional devices. It might be easier for you to route any cables before you install certain optional devices.
The following illustration shows the locations of the input and output connectors on the rear of the server.
