IBM SY27-0345-06 manual Installing the Adapter Power Supply, Assembling the Riser

Turn over the cover.

Place the insulator inside the top of the cover.

to delete any virtual interfaces, for example, dial circuits, assoc
adapter	prior to	removing	the adaptertalk 6 delete.	Theinterface		command
deletes	the interface you explicitly state				in	the	command	line. The
current	use will	not be	deleted unless	you	specify		that	interface
command	line.

If the guide rails are visible, the feature is installed and you lation at “Installing Optional Adapters” on page 4-36.

If the guide rails are not visible, you should begin the installati Adapter Power Supply.”

Installing the Adapter Power Supply

1Remove the cover as directed in “Removing the Cover” on page 4- already removed.

2 Remove the power supply cover and keep the three fastening scr “Removing the Base Power Supply for 14T and 24x Models” on page for detailed instructions.

3

4

5

Place

the power supply on the insulator

and

fasten it

in

positio

the

power

supply cover

using

the four

securing

screws.

6

Attach

the

dc

power

cable

to

the

power

supply

and

feed the

the

access

slot.

7

Attach

the

ac

power

cable

to

the

power supply and replace the

the

existing power supply, using

the

original screws. Make

sure t

of the cover goes under the lip of the frame.

Assembling the Riser

Card

Refer to “Handling Static-Sensitive Devices” on page 4-2 before removin

installing

the riser

card

to

the

system

board.

Chapter 4. Removal and Replacement Procedures4-33