JVC VR-716E instruction manual Mounting to a Rack, Turning On/Off the Power

Mounting to a Rack

Make use of the rack-mounting bracket provided when mounting VR-716 to the EIA rack.

1

3

Rack-mounting

Bracket

1. Mount the rack-mounting bracket to VR-716 us- ing Screw 1

• Fasten the two sides of VR-716 using the 4 screws provided (M4 x 10 mm).

3 1

2 (4 corners)

Caution

•Do not place any object on VR-716 that has been mounted onto the rack. This may cause the rack to give way and lead to inju- ries or equipment damages.

•When mounting 2 or more VR-716 record- ers on racks, ensure that they are mounted at least 1 unit away from one another.

2. Remove Screw 2 (4 corners) on the foot stand at the bottom surface of the equipment

•Remove the foot stand.

3.Mount VR-716 to the rack using Screw 3

•Fasten the equipment to the rack using the 4 screws provided (M5 x 10 mm).

Turning On/Off the Power

Notes

•Refer to page 62 ‘External Hard Disk Drives’ when adding external HDDs.

•Operation of power is disabled during sys- tem checks.

Do so after the “SYSTEM CHECKING...

PLEASE WAIT…” display disappears.

Caution

•Turn ON the power of this equipment only after connections with all peripheral devices are completed.

•Do not unplug the power cord when start- ing up this equipment. This may cause the equipment to malfunction.

[OPERATE]

				CANCEL	SEARCH	MENU		HDD	OPERATE
1	2	ALARM	5	6			REV	FWD
		SENSOR

3	4	ALARM	7	8				TIMER		LOCK
		SENSOR
9	10	ALARM	13	14							OUT
		SENSOR						DISPLAY	EXECUTE
				SEQUENCE						VIDEO	AUDIO
				MULTI	REC	STOP	PLAY	STILL
11	1	ALARM	15	16						SKIP
		SENSOR

Front Display

Note

•Press the [OPERATE] button once when in the OFF state to turn ON the power.

Caution

•Unplug the power cord only when the power of the equipment is OFF. If the power cord is unplugged when the equipment is in ON state, it will take time to perform a hard disk check when it is turned on again. It may take a long time when the data is fragmented or when there is a large amount of recorded data.

⬛Turning ON the Power

1. Connect the power cord

•Use the power cord supplied to connect to an AC 220 V - 240 V, 50 Hz/ 60 Hz outlet.

•This turns ON the power and starts the system check.

<Monitor>

SYSTEM CHECKING... PLEASE WAIT...

<Front Display>

⬛Turning OFF the Power

1. Press the [OPERATE] button for about 2 seconds

•The front display shows [BUSY] and switches to a dim clock display. (OFF State)

<Front Display>

OPERATE

2. Unplug the power cord

15