JVC VR-716E Hard Disk Recovery Feature, Press the Operate button, Hard disk drives are now usable

6.

SEARCH	MENU	HDD	OPERATE
	REV	FWD
			LOCK
	EXECUTE		OUT
			VIDEO AUDIO
		SKIP

4.5.

Notes

•If the “HDD RECONFIGURING” screen is not displayed upon turning on the power again, this means the connection is faulty. Turn off the power of VR-716 and the exter- nal hard disk drives and check if the cables, terminator and power supply are properly connected.

•Press the [CANCEL] button when the HDD Reconfiguration screen is displayed to ter- minate the process. Upon terminating, turn off the power of VR-716.

•Disconnection instead of formatting will be executed when “DISCONNECT” is selected for the alteration of connection setup. The “NOW DISCONNECTING...” z “DISCON- NECTING SUCCEEDED” messages will be displayed on the screen.

•Formatting time required for each external hard disk drive (120 GB) is about 30 sec- onds.

•Recording and playback are not possible when altering connection setup.

•The hard disk capacity displayed on the

screen	is calculated based on
1 GB =	(1024)3 Bytes. Therefore it is dis-

played as lower than the actual capacity.

Caution

•At the screen upon completion of “FOR- MAT”, never unplug the power cord.

4. Press the [EXECUTE] button

• This displays the “CONFIRM HDD
RECONFIGURING” Screen.	CONFIRM HDD RECONFIGURING
EXECUTE	ALL RECONFIGURED HDD DATA IS DELETED!
		START?
	[CANCEL]:CANCEL	[EXEC]:START

5. Press the [EXECUTE] button again

•This starts the formatting of the external hard disk drive.

•Upon completion, the “FORMAT SUCCEEDED” screen will be dis- played.

EXECUTE EXTERNAL HDD4 : NOW FORMATTING...

EXTERNAL HDD 4 : FORMAT SUCCEEDED

MIRRORING SETING

HDD UPDATE IS COMPLETED

PRESS [OPERATE] FOR OPERATION

6. Press the [OPERATE] button

• The hard disk drives are now usable.

OPERATE

Hard Disk Recovery Feature

Note

•The following operations are not possible when error [E-01] is displayed:

•“TIME ZONE SETTING”

•“DEFRAG DATABASE”

•“FORMAT”

•“MIRRORING”

•“DVD-RAM COPY”

This unit is incorporated with automatic recovery feature. When there is fail- ure on the hard disk, it will restart and recover automatically. Upon restart, recording will continue with the remaining hard disk after the hard disk which failure occurred had been automatically disconnected. Recording is disabled during restart. Error code [E-01] will be displayed on the front display after automatic restart.

To return to the normal display from error code display, turn [OPERATE] to off once and then turn [OPERATE] to on again.

Automatic recovery is not possible in the case of severe failure where it can- not be rebooted.

63