Leica DMI3000B, DMI6000B, DMI4000B manual Start-up Switching on the Microscope

7. Start-up

7.2 Switching on the Microscope

Leica DMI3000 B:

¥Switch on the microscopeÕs power at the On/ Off switch . The signal lamp is lit when the in- strument is ready. (For the Leica DMI3000 B please continue at 7.4. Function Buttons on the Stand)

Leica DMI4000 B and Leica DMI6000 B:

¥Switch on the power of the electronics box at the On/Off switch (80.1). The signal lamp (80.2) is lit green when the unit is ready. All motor- ized microscope components will then run through an initialization phase.

Note:

If a PC is connected, switch on the electronics box first, and then the computer.

After the initialization (Fig. 81) is complete, the LeicaScreen will display the microscopeÕs cur- rent settings (Fig. 82).

Fig. 80

front side Leica CTR6000

1On/Off switch

2Signal lamp

2

1

If a component has not been installed correctly, the LeicaScreen will display an error message. See Troubleshooting chapter, → p. 102. Components such as diaphragms, condensers, light and phase rings have been pre-centered at the factory. It may be necessary to correct the centering after the microscope has been trans- ported and assembled.

Before performing the required steps, please fa- miliarize yourself with the LeicaScreen and the controls.

Caution!

After turning on the gas discharge lamp, the burner must be immediately adjusted. There- fore, do not turn on the power supply unit yet. First, work in transmitted light in order to familiarize yourself with the microscopeÕs controls.

Fig. 81

LeicaScreen

Initialization

Fig. 82

LeicaScreen after Initialization

63