6. Assembly

CTR6000 and CTR6500 electronics box:

6.18 Connection to the Computer

Note:

Note:

These electronics boxes must not be used with other stands. The serial number of the associated stand has been recorded on the back of the elec- tronics box.

A3-axis control unit for focus and 3-plate cross stages is integrated in the CTR6000.

A3-axis control unit for focus and a scanning stage is integrated in the CTR6500.

¥Connect the Microscope (77.6) socket to the back of the stand (78.5) using the 25-pin mi- croscope cable.

¥Connect the SmartMove remote control module to the XYZ-Controlsocket (77.5).

¥Connect the motorized stage, if present, to the XY-Stagesocket (77.2).

¥Connect the lamp power cable (78.7) to the 12 V, max 100 W socket (77.7).

To start the Leica Application Suite (LAS), en- sure that the COM1 serial port is not in use by another program or driver. This is frequently the case when using Palms or other PDAs or when using external modems or other devices. The devices in question must therefore always be disabled before using the Leica Application Suite (LAS) software.

¥Please use the included serial cable. Connect the COM1 port of your PC with the RS232C port (78.1) on the back of the stand.

6.19 Connection to the Power Supply

¥Once all installation work is complete, con- nect the electronics box to an AC power outlet with the included power cable (socket 77.1).

¥If you are using the external ebq 100 supply unit, connect it to an AC power outlet at this time (socket 79.1).

Caution!

Ensure that the plugs are correctly inserted and secured to prevent overheating of the sockets.

Fig. 79 Rear panel of ebq 100 supply unit

1AC power supply socket

1

58

Page 57 Page 59
Page 58
Image 58
Leica DMI6000B, DMI3000B, DMI4000B manual Assembly CTR6000 and CTR6500 electronics box, Connection to the Power Supply
Page 57 Page 59
Top Page Image Contents