Leica DMI4000B, DMI3000B Operation, Switching on, If a PC is connected, switch on the electronics

8. Operation

8. Operation

8.1 Switching on

When using a gas discharge lamp, the ebq 100 external supply unit must be turned on sepa- rately (104.1).

Leica DMI3000 B:

¥Switch on the microscope's power at the On/Off switch. The signal lamp is lit when the instrument is ready. (Continue with Chapter 8.2 Contrast Methods)

Leica DMI4000 B and Leica DMI6000 B:

¥Switch on the power of the electronics box at the On/Off switch (105.1). The signal lamp (105.2) is lit green when the unit is ready.

All motorized microscope components will then run through an initialization phase.

Note:

If a PC is connected, switch on the electronics

box first, and then the computer.

All motorized microscope components will then run through an initialization phase.

Note:

In the case of faulty initialization (ÒInit ErrorÓ message on LeicaScreen), see Troubleshooting chapter, → p. 102.

Fig. 105

front side Leica CTR6000

		1	On/Off switch
Fig. 104 Front panel of ebq 100 supply unit		2	Signal lamp
1	Power switch
2	Lamp status

2

1

12

80