Lexmark MS710, MS835 Parallel x menu, Understanding printer menus 104, ENA Address, ENA Netmask

Understanding printer menus		104
	Use	To
	ENA Address	Set the network address information for an external print server.
	yyy.yyy.yyy.yyy	Note: This menu is available only when the printer is attached to an external print
		server through the USB port.
	ENA Netmask	Set the netmask information for an external print server.
	yyy.yyy.yyy.yyy	Note: This menu is available only when the printer is attached to an external print
		server through the USB port.
	ENA Gateway	Set the gateway information for an external print server.
	yyy.yyy.yyy.yyy	Note: This menu is available only when the printer is attached to an external print
		server through the USB port.

Parallel [x] menu

Note: This menu appears only when an optional parallel card is installed.

Use	To
PCL SmartSwitch	Set the printer to automatically switch to PCL emulation when a print job received
On	through a serial port requires it, regardless of the default printer language.
Off	Notes:
	• On is the factory default setting.
	• When set to Off, the printer does not examine incoming data. The printer uses
	PostScript emulation if PS SmartSwitch is set to On. It uses the default printer
	language specified in the Setup menu if PS SmartSwitch is set to Off.
PS SmartSwitch	Set the printer to automatically switch to PS emulation when a print job received
On	through a serial port requires it, regardless of the default printer language.
Off	Notes:
	• On is the factory default setting.
	• When set to Off, the printer does not examine incoming data. The printer uses
	PCL emulation if PCL SmartSwitch is set to On. It uses the default printer
	language specified in the Setup menu if PCL SmartSwitch is set to Off.
NPA Mode	Set the printer to perform the special processing required for bidirectional
On	communication following the conventions defined by the NPA protocol.
Off	Notes:
Auto	• Auto is the factory default setting.
	• Changing this setting from the printer control panel and then exiting the
	menus causes the printer to restart. The menu selection is then updated.