Lexmark MS832, MS835, MS710 manual Understanding printer menus 115

Understanding printer menus		115
	Use	To
	Timeouts	Set the printer to operate at a low power state.
	Hibernate Timeout	Notes:
	Disabled
		• When the Hibernate Timeout timer expires, the printer uses
	1 hour
		Ethernet connection to check the value of “Hibernate
	2 hours
		Timeout on Connection.”
	3 hours
		• If “Hibernate Timeout on Connection” is set to “Do Not
	6 hours
		Hibernate,” then the printer never automatically hibernates.
	1 day
		• If “Hibernate Timeout on Connection” is set to “Hibernate,”
	2 days
		then the printer follows the Hibernate Timeout value, except
	3 days
		when it is set to Disabled.
	1 week	• Disabled is the factory default setting except for European
	2 weeks
		Union countries and Switzerland.
	1 month	• “3 days” is the factory default setting for European Union
		countries and Switzerland.
	Timeouts	Set the printer to follow the setting of “Hibernate Timeout” even
	Hibernate Timeout on Connection	when an active Ethernet connection exists.
	Do Not Hibernate	Notes:
	Hibernate	• “Do Not Hibernate” is the factory default setting.
		• If “Hibernate Timeout on Connection” is set to “Do Not
		Hibernate,” then the printer never automatically hibernates.
		• If “Hibernate Timeout on Connection” is set to “Hibernate,”
		then the printer follows the value of the “Hibernate
		Timeout” setting, except when it is set to Disabled.
	Timeouts	Set the amount of time in seconds the printer waits before
	Screen Timeout	returning the display to the Ready state.
	15–300 sec	Note: “30 sec” is the factory default setting.
	Timeouts	Set the amount of time in seconds the printer waits to receive an
	Print Timeout	end‑of‑job message before canceling the remainder of the print
	Disabled	job.
	1–255 sec	Notes:
		• “90 sec” is the factory default setting.
		• When the timer expires, any partially printed page still in the
		printer is printed, and then the printer checks to see if any
		new print jobs are waiting.
		• Print Timeout is available only when using PCL emulation.
		This setting has no effect on PostScript emulation print jobs.
	Timeouts	Set the amount of time in seconds the printer waits for additional
	Wait Timeout	data before canceling a print job.
	Disabled	Notes:
	15–65535 sec	• “40 sec” is the factory default setting.
		• Wait Timeout is available only when the printer is using
		PostScript emulation. This setting has no effect on PCL
		emulation print jobs.