Lexmark MS835, MS832 Understanding printer menus 123, Staple Job, Run Stapler Test, Offset Pages

Understanding printer menus		123
	Use	To
	Paper Saver Border	Print a border when using Paper Saver.
	None	Note: None is the factory default setting.
	Solid
	Staple Job	Specify whether printed output is stapled.
	Off	Notes:
	On
		• Off is the factory default setting.
		• This menu appears only when a supported staple finisher is installed.
	Run Stapler Test	Print a report that confirms that the staple finisher is functioning properly.
		Note: This menu appears only when a supported staple finisher is installed.
	Hole Punch	Specify whether holes will be created on printed outputs for the purpose of collecting
	On	the sheets in a binder or folder.
	Off	Notes:
		• Off is the factory default setting.
		• This menu appears only when a supported staple, hole punch finisher is
		installed.
	Hole Punch Mode	Specify the number of holes to be created on printed outputs for the purpose of
	2 holes	collecting the sheets in a binder or folder.
	3 holes	Notes:
	4 holes	• “3 holes” is the U.S. factory default setting. “4 holes” is the international
		factory default setting.
		• This menu appears only when a supported staple, hole punch finisher is
		installed.
	Offset Pages	Offset pages at certain instances.
	None	Notes:
	Between Copies
		• None is the factory default setting.
	Between Jobs
		• Between Copies inserts a blank sheet between each copy of a print job if
		Collate is set to “(1,2,3) (1,2,3).” If Collate is set to “(1,1,1) (2,2,2),” then a
		blank page is inserted between each set of printed pages, such as after all
		page 1's and after all page 2's.
		• Between Jobs sets the same offset position for the entire print job regardless
		of the number of copies printed.
		• This menu appears only when a supported staple finisher is installed.