Lexmark MS710, MS835 Verifying printer setup, Printing a menu settings, Click Continue Finish

Additional printer setup 47

dFollow the instructions on the computer screen.

eSelect Advanced, and then click Continue.

fFrom the Configure Printer Connection dialog, select a port.

gIf the port is not in the list, then click Refresh, or navigate to:

Add port > select a port type > enter the necessary information > OK

hClick Continue > Finish.

3Set the COM port parameters.

After installing the printer driver, set the serial parameters in the COM port assigned to the printer driver.

Note: Make sure the serial parameters in the COM port match the serial parameters you set in the printer.

aOpen Device Manager.

In Windows 8

From the Search charm, type run and then navigate to: Apps list > Run > type devmgmt.msc > OK

In Windows 7 or earlier

1Click , or click Start and then click Run.

2In the Start Search or Run dialog, type devmgmt.msc.

3Press Enter or click OK.

bDouble‑click Ports (COM & LPT) to expand the list of available ports.

cDo either of the following:

•Press and hold the COM port where you attached the serial cable to your computer (example: COM1).

•Right‑click the COM port where you attached the serial cable to your computer (example: COM1).

dFrom the menu that appears, select Properties.

eOn the Port Settings tab, set the serial parameters to the same serial parameters set in the printer. Check the serial heading of the menu settings page for the printer settings.

fClick OK, and then close all the dialogs.

gPrint a test page to verify printer installation.

Verifying printer setup

Printing a menu settings page

Print a menu settings page to review the current menu settings and to verify if the printer options are installed correctly.

Note: If you have not changed any menu settings, then the menu settings page lists all the factory default settings. When you select and save other settings from the menus, they replace the factory default settings as user default settings. A user default setting remains in effect until you access the menu again, choose another value, and save it.

From the printer control panel, navigate to:

> Settings > >Reports > > Menu Settings Page >