Lexmark MS710, MS835, MS832 manual PCL Emul menu, Understanding printer menus 128

Understanding printer menus 128

PCL Emul menu

Use	To
Font Source	Specify the set of fonts used by the Font Name menu.
Resident	Notes:
Disk
	• “Resident” is the factory default setting. Resident shows the factory
Download
	default set of fonts downloaded in the RAM.
Flash
	• “Flash” and “Disk” settings show all fonts resident in that option.
All
	• The flash option must be properly formatted and cannot be read/write‑,
	write‑, or password‑protected.
	• “Download” shows all the fonts downloaded in the RAM.
	• “All” shows all fonts available to any option.
Font Name	Identify a specific font and the option where it is stored.
Courier 10	Note: Courier 10 is the factory default setting. Courier 10 shows the font
	name, font ID, and the storage location in the printer. The font source
	abbreviation is R for Resident, F for Flash, K for Disk, and D for Download.
Symbol Set	Specify the symbol set for each font name.
10U PC‑8	Notes:
12U PC‑850	• 10U PC‑8 is the US factory default setting. 12U PC‑850 is the international
	factory default setting.
	• A symbol set is a set of alphabetic and numeric characters, punctuation,
	and special symbols. Symbol sets support the different languages or
	specific programs such as math symbols for scientific text. Only the
	supported symbol sets are shown.
PCL Emulation Settings	Change the point size for scalable typographic fonts.
Point Size	Notes:
1.00–1008.00
	• 12 is the factory default setting.
	• Point size refers to the height of the characters in the font. One point
	equals approximately 0.014 inch.
	• Point sizes can be increased or decreased in 0.25‑point increments.
PCL Emulation Settings	Specify the font pitch for scalable monospaced fonts.
Pitch	Notes:
0.08–100
	• 10 is the factory default setting.
	• Pitch refers to the number of fixed‑space characters per inch (cpi).
	• Pitch can be increased or decreased in 0.01‑cpi increments.
	• For nonscalable monospaced fonts, the pitch appears on the display but it
	cannot be changed.
PCL Emulation Settings	Specify the orientation of text and graphics on the page.
Orientation	Notes:
Portrait
	• Portrait is the factory default setting. Portrait prints text and graphics
Landscape
	parallel to the short edge of the page.
	• Landscape prints text and graphics parallel to the long edge of the page.